Run - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

6
Root (:) Commands

:RUN

Command Syntax
:RUN
The :RUN command starts repetitive acquisitions. This is the same as
pressing the Run key on the front panel.
See Also •
•
•
Example Code
See complete example programs at:
starting on page 799
176
(see page 790)
"Introduction to Root (:) Commands"
":SINGle" on page 178
":STOP" on page 180
' RUN_STOP - (not executed in this example)
' - RUN starts the data acquisition for the active waveform display.
' - STOP stops the data acquisition and turns off AUTOSTORE.
' myScope.WriteString ":RUN"
' myScope.WriteString ":STOP"
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
on page 150
' Start data acquisition.
' Stop the data acquisition.
Chapter 38, "Programming Examples,"