Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual page 447

Control the modes and parameters for each serial bus decode/trigger type.
See:
• "Introduction to :SBUS<n> Commands"
• "General :SBUS<n> Commands"
• ":SBUS<n>:CAN Commands"
• ":SBUS<n>:IIC Commands"
• ":SBUS<n>:LIN Commands"
• ":SBUS<n>:SPI Commands"
• ":SBUS<n>:UART Commands"
Introduction to
The :SBUS subsystem commands control the serial decode bus viewing,
:SBUS<n> mode, and other options.
Commands
These commands are only valid on oscilloscope models when a serial decode option has
N O T E
been licensed.
The following serial bus decode/trigger types are available (see
":TRIGger:MODE"
• CAN (Controller Area Network) triggering— will trigger on CAN
version 2.0A and 2.0B signals. Setup consists of connecting the
oscilloscope to a CAN signal. Baud rate, signal source, and signal
polarity, and type of data to trigger on can be specified. You can trigger
on CAN data and identifier patterns and you can set the bit sample
point.
• IIC (Inter- IC bus) triggering— consists of connecting the oscilloscope
to the serial data (SDA) line and the serial clock (SCL) line, then
triggering on a stop/start condition, a restart, a missing acknowledge, or
on a read/write frame with a specific device address and data value.
• LIN (Local Interconnect Network) triggering— will trigger on LIN sync
break at the beginning of a message frame.You can trigger on Sync
Break, Frame IDs, or Frame IDs and Data.
Agilent InfiniiVision 2000 X-Series Oscilloscopes
Programmer's Guide
25
:SBUS<n> Commands
on page 452
on page 469
on page 479
on page 493
on page 509
on page 598).
s1
on page 447
on page 449
447