Sre (Service Request Enable) - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

5
Common (*) Commands

*SRE (Service Request Enable)

Command Syntax
*SRE <mask>
<mask> ::= integer with values defined in the following table.
The *SRE command sets the bits in the Service Request Enable Register.
The Service Request Enable Register contains a mask value for the bits to
be enabled in the Status Byte Register. A one in the Service Request
Enable Register enables the corresponding bit in the Status Byte Register.
A zero disables the bit.
140
(see page 790)
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide