System Installation
■
■
■
■
■
■
■
■
■
■
■
■
© Agilent Technologies 2010
Medalist i3070 System Installation
Tools
Required, 1-2
Getting
Started, 1-3
Setting Up the Support Arm with Monitor, Keyboard,
and
Mouse, 1-4
Setting Up the Strip
Printer, 1-15
Preparing the
Testhead, 1-16
Powering the PDU and
Controller, 1-19
Installing a Support Bay and Instrument
Enabling the
Testhead, 1-25
Verifying the Vacuum
Subsystem, 1-28
Verifying the
Testhead, 1-32
Completing the
Installation, 1-33
In Case of
Difficulty, 1-34
CAUTION
The Medalist In-circuit Test System should only
be installed by an Agilent-Authorized Service
Representative.
Testhead boot conflicts may occur if this system is
on a network with Medalist 3070 UNIX
controllers with IP addresses other than in the
10.3.112.XX series.
Rack, 1-21
CAUTION
The Medalist test development software requires
that decimals in the board file use a period (.) and
not any other character such as a comma. Make
use that Windows is set to use a period for
decimals. (Select Control Panel > Regional and
Language Options > Regional Options tab. Click
Customize; in the Numbers tab ensure that the
selected Decimal symbol is a period.)
1-1