Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual page 27

Command
:SEARch:SERial:IIC
Commands (see
:SEARch:SERial:LIN
Commands (see
:SEARch:SERial:SPI
Commands (see
:SEARch:SERial:UART
Commands (see
:SEARch:STATe (see
:TRIGger:LEVel:ASETup (see
page
Changed
Commands
Command
:BLANk (see
:DIGitize (see
:SAVE:WAVeform:FORMat
(see
:STATus (see
:SYSTem:MENU (see
page
:VIEW (see
:WAVeform:SOURce (see
page
:WAVeform:SOURce:SUBSour
ce (see
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
page 542)
page 549)
page 555)
page 559)
page 535)
595)
page 158)
page 159)
page 440)
page 179)
569)
page 182)
649)
page 653)
Differences
Commands for finding IIC events in the captured data.
Commands for finding LIN events in the captured data.
Commands for finding SPI events in the captured data.
Commands for finding UART/RS232 events in the captured
data.
Enables or disables the search feature.
Sets the trigger levels of all displayed analog channels to their
waveforms' 50% values.
Differences
You can now use the SBUS1 source parameter to turn off the
serial decode display.
You can now use the SBUS1 source parameter to acquire the
serial waveform.
The ALB format is no longer supported.
You can now use the SBUS1 source parameter to view the serial
decode display status.
The LISTer parameter is now available.
You can now use the SBUS1 source parameter to turn on the
serial decode display.
Can select SBUS1 as the waveform source.
With the SPI and UART/RS232 serial decode options,
subsources are now valid in the 2000 X-Series oscilloscopes.
1
What's New
27