Marker:ydelta - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

:MARKer:YDELta

Query Syntax
:MARKer:YDELta?
The :MARKer:YDELta? query returns the value difference between the
current Y1 and Y2 cursor positions.
Ydelta = (Value at Y2 cursor) - (Value at Y1 cursor)
If the front-panel cursors are off or are set to Binary or Hex Mode, the marker position
N O T E
values are not defined. Make sure to set :MARKer:MODE to MANual or WAVeform to put
the cursors in the front-panel Normal mode.
Y cursor units are set by the :MARKer:YUNits command.
Return Format
<value><NL>
<value> ::= difference value in NR3 format
See Also
•
•
•
•
•
•
•
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
(see page 790)
"Introduction to :MARKer Commands"
":MARKer:MODE" on page 319
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YUNits" on page 330
on page 318
on page 321
on page 323
on page 327
on page 328
19
:MARKer Commands
329