Measure:thresholds - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

33
Obsolete and Discontinued Commands

:MEASure:THResholds

Command Syntax
:MEASure:THResholds {T1090 | T2080 | VOLTage}
The :MEASure:THResholds command selects the thresholds used when
making time measurements.
The :MEASure:THResholds command is obsolete and is provided for backward
N O T E
compatibility to previous oscilloscopes. Use the :MEASure:DEFine THResholds command
(see
Query Syntax
:MEASure:THResholds?
The :MEASure:THResholds? query returns the current thresholds selected
when making time measurements.
Return Format
{T1090 | T2080 | VOLTage}<NL>
{T1090} uses the 10% and 90% levels of the selected waveform.
{T2080} uses the 20% and 80% levels of the selected waveform.
{VOLTage} uses the upper and lower voltage thresholds set by the
UPPer and LOWer commands on the selected waveform.
See Also •
•
•
728
(see page 790)
page 344) instead.
"Introduction to :MEASure Commands"
":MEASure:LOWer" on page 725
":MEASure:UPPer" on page 733
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
on page 340