Ip Dhcp Pool - Enterasys X-Pedition XSR CLI Cli Reference Manual

DHCP Commands
Syntax
ip dhcp ping timeout milliseconds
milliseconds
Syntax of the "no" Form
Use the no form of this command to restore the ping timeout default:
no ip dhcp ping timeout
Default
500 milliseconds
Mode
Global configuration:
Example
The following example specifies that the DHCP server will wait 900 milliseconds for a ping reply
before considering the ping a failure:
XSR(config)#ip dhcp ping timeout 900

ip dhcp pool

This command configures a DHCP server IP address pool. The XSR supports adding 1000
network addresses per pool and one DHCP pool per network. Class B or higher subnet masks are
supported.
Syntax
ip dhcp pool name
name
Syntax of the "no" Form
Use the no form of this command to remove the address pool:
no ip dhcp pool name
Default
DHCP address pools are not configured
15-94 Configuring DHCP
The interval the DHCP server waits for a ping reply before it stops trying to
reach an IP address for client assignment. The peak timeout is 10 seconds.
XSR(config)#
Note: The DHCP pool name must match the name given the IP local pool.
A character string or integer which match the name you designate for the IP local pool.