Enterasys X-Pedition XSR CLI Cli Reference Manual page 141

Mode
Interface configuration:
Default
Sync
Example
XSR(config-if<S1/0>)#physical-layer async
shutdown
This command disables an interface. When the interface is created, it is disabled by default.
Syntax
shutdown
Syntax of the "no" Form
no shutdown
Mode
Interface configuration:
Default
When the interface is created, it is disabled by default.
Example
XSR(config-if<S1/0>)#no shutdown
speed
This command, used in conjunction with the
to operate at a specific speed and/or duplex mode. Setting the speed or duplex to auto‐negotiate
implies that both the speed and the duplex mode will be negotiated. It is not possible to manually
set one and auto‐negotiate the other. For example, you cannot set the speed to 10 Mb/s and set the
duplex to auto‐negotiate.
For GigabitEthernet only, to set 1000 Mbits speed for copper or fiber, select
autosense the correct line and duplex speeds.
Keep in mind the following caveats:
• Changing the speed preserves the current duplex mode.
XSR(config-if<Sx>)#
Note: Issuing this command causes the interface to drop its link while disabled.
XSR(config-if<xx>)#
duplex command, forces the FastEthernet interface
Hardware Controller Commands
auto which will
XSR CLI Reference Guide 4-89