Enterasys X-Pedition XSR CLI Cli Reference Manual page 512

CMV Commands
Syntax
cmv delete command-ID offset [value]
command-ID
offset
value
Mode
ATM Interface configuration:
Example
The following example deletes CMV OPTN2, from the retaining list:
XSR(config-if<ATM0/1/1>)#cmv delete OPTN 2
cmv print
This command prints the Command Management Variable (CMV) training list on the console. The
training list is used by the DSP firmware when the line is in training mode. This command is
intended for use by Enterasys field service personnel only.
This command requires that the ADSL NIM be installed and the DSP firmware file be present in
the Flash:
Syntax
cmv print
Mode
ATM Interface configuration:
Example
The following example prints the CMV training list to the console:
XSR(config-if<ATM0/1/1>)#cmv print
cmv save
This command saves the Command Management Variable (CMV) training list to a file. The
training list is used by the DSP firmware when the line is in training mode. This command is
intended for use by Enterasys field service personnel only.
This command requires that the ADSL NIM be installed and the DSP firmware file be present in
Flash:
the
13-86 Configuring ADSL
Represents a 4‐character CMV command.
Decimal or hexadecimal number representing where to write the value.
Decimal or hexadecimal number
XSR(config-if<ATMxx>)#
directory.
XSR(config-if<ATMxx>)#
directory.