Enterasys X-Pedition XSR CLI Cli Reference Manual page 557

Syntax of the "no" Form
The no form of this command removes policies from the peer:
no proposal
Mode
Remote Peer ISAKMP protocol policy configuration:
Example
The following example attaches a proposal to the remote peer:
XSR(config)#crypto isakmp peer 192.168.57.9 255.255.255.255
XSR(config-isakmp-peer)#proposal 3des_md5_gh2
user-id
This command defines the identity information to be used during aggressive IKE Phase 1
negotiation for peer‐to‐peer connections. Enter it when configuring the peer's ISAKMP for a peer
with pre‐shared keys whose IP address is dynamic. If you specify no ID, the IP address will be used
by default. But, in that case, you will have to re‐configure (with a new entry in the
database) both ends of the tunnel every time the address changes.
Syntax
user-id "string"
"string"
Syntax of the "no" Form
The no form of this command deletes the user identity:
no user-id "string"
Mode
Privileged EXEC:
Example
The following example configures the identification ROBO1. This ID will be used for aggressive
IKE Phase 1 messages sent to the peer matching the ISAKMP's peer address (0.0.0.0, for example):
XSR(config)#crypto isakmp peer 0.0.0.0 0.0.0.0
XSR(config-isakmp-peer)#exchange-mode aggressive
XSR(config-isakmp-peer)#user-id "ROBO1 in Shrewsbury"
Note: The exchange mode for this ISAKMP must be set to aggressive.
User‐defined identification enclosed by quotations.
XSR#
Remote Peer ISAKMP Protocol Policy Mode Commands
XSR(config-isakmp-peer)#
XSR CLI Reference Guide 14-103
aaa user