Table of Contents
Advertisement
PPP Commands
Example
The following example sets Serial interface 1/0 to have keepalive configured at 8‐second intervals:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#encapsulation ppp
XSR(config-if<S1/0>)#no shutdown
XSR(config-if<S1/0>)#ppp keepalive 8
ppp lcp max-configure
This command configures the restart timer counter for the peak number of Configure‐Requests
sent out on a Point‐to‐Point interface. Using the Link Control Protocol (LCP), the command
applies to any Serial, or Dialer port, or Fast/GigabitEthernet sub‐interface on which PPP
encapsulation is set. This counter totals the peak number of configure requests sent without
receiving a Configure‐Ack, Configure‐Nak or Configure‐Reject.
Syntax
ppp lcp max-configure number
number
Syntax of the "no" Form
The no command resets the counter to the default value:
no ppp lcp max-configure
Default
10
Mode
Serial, Dialer or Fast/GigabitEthernet sub‐interface configuration:
Example
The following example sets the LCP max‐configure value at 2 requests:
XSR(config)#interface dialer 2
XSR(config-if<D2>)#ppp lcp max-configure 2
ppp lcp max-failure
This command configures the counter for the maximum number of Configure‐Nak packets sent
out on a Point‐to‐Point interface. Using the Link Control Protocol (LCP), the command applies to
any Serial or Dialer port, or Fast/GigabitEthernet sub‐interface on which PPP encapsulation is set.
This counter totals the peak number of Configure‐Nak packets to send; subsequent Nak packets
are converted to Configure‐Reject packets.
8-90 Configuring the Point-to-Point Protocol
Setting for the configure‐request counter, ranging from 1 to 255.
XSR(config-if<xx>)#
Advertisement
Table of Contents
