Enterasys X-Pedition XSR CLI Cli Reference Manual page 216

RTP Header Compression Commands
Mode
Interface configuration:
This command is applicable only on serial interface with PPP encapsulation.
Note: The XSR currently does not block this command on ʺinterface dialerʺ and on ʺinterface
multilinkʺ, but the command has no effect on these interfaces.
This command requires a reboot of the interface to take effect.
Example
The following example enables RTP header compression on PPP serial interface S1/0:
XSR(config-if<S1/0>)#ip rtp header-compression
ip rtp range
This command specifies the destination port range of UDP packets used to screen for RTP
compression.
Syntax
ip rtp range starting-port-Num end-Port-Num
starting-port-Num
end-port-Num
Syntax of the "no" Form
The no command removes the RTP packet ranges
no ip rtp range
Default
Disabled
Mode
Interface configuration:
This command is applicable only on serial interface with PPP encapsulation.
Note: The XSR currently does not block this command on ʺinterface dialerʺ and on ʺinterface
multilinkʺ, but the command has no effect on these interfaces.
Example
The following example set the RTP header range from UDP port 1325 to UDP port 1400, for serial
interface S1/0:
XSR(config-if<S1/0>)# ip rtp range 325 400
5-140 Configuring the Internet Protocol
XSR(config-if<xx>)#
Starting destination UDP port number. Range: 1024 to 65535
Ending Destination UDP port number. Range: 1024 to 65535
Note: The end‐port‐number must be larger or equal to the starting‐
port‐num.
XSR(config-if<xx>)#