Enterasys X-Pedition XSR CLI Cli Reference Manual page 186

OSPF Debug and Show Commands
It is
Summary Link update
interval
External Link update
interval
Redistributing
External Routes from
Number of areas in
this router
Number of interfaces
in this area
Area authentication
SPF algorithm
executed
Area ranges
show ip ospf border-routers
This command displays information about OSPF internal route table entries to ABRs and ASBRs.
Syntax
show ip ospf border-routers
Mode
EXEC or Global configuration:
Sample Output
The following is sample output:
XSR>show ip ospf border-routers
OSPF internal Routing Table
Codes: i - Intra-area route, I - Inter-area route
i 192.168.22.1 [64] via 192.168.11.1, Serial1, ABR, Area 0, SPF 10
i 192.168.22.1 [64] via 192.168.11.1, Serial1, ABR, Area 4, SPF 10
i 192.168.44.1 [64] via 192.168.33.1, Serial2, ABR, Area 0, SPF 10
i 192.168.44.1 [64] via 192.168.33.1, Serial2, ABR, Area 2, SPF 7
i 192.168.44.2 [64] via 192.168.33.1, Serial2, ABR, Area 0, SPF 10
i 192.168.44.2 [64] via 192.168.11.1, Serial1, ABR, Area 0, SPF 10
Parameter Descriptions
Router ID
Cost
5-110 Configuring the Internet Protocol
OSPF router designation. Valid values: area border, autonomous
system boundary, and internal.
Update interval for summary LSAs generated by this router.
Update interval for external LSAs generated by this router.
Valid redistributed routes: static, RIP, OSPF.
Sum of areas this router belongs to followed by types of areas.
Sum of interfaces assigned to this area.
Type of authentication used for this area.
Number of times the SPF algorithm is run on this router for this area.
Summarized area ranges.
XSR> XSR(config)#
or
OSPF router ID of the destination border router.
OSPF cost or metric of reaching a border router identified by the router ID.