Ospf Debug And Show Commands - Enterasys X-Pedition XSR CLI Cli Reference Manual

OSPF Debug and Show Commands

OSPF Debug and Show Commands
debug ip ospf dr
This command debugs OSPF designated router events. As with all XSR debug commands, it is set
to privilege level 15 by default.
Syntax
debug ip ospf dr
Syntax of the "no" Form
The no form of this command returns the debug function to the default:
no debug ip ospf dr
Mode
EXEC configuration: XSR>
Example
The following example indicates the election of a designated router:
OSPF: Elect DR. dr:53.53.53.21 bdr:53.53.53.6 GigabitEthernet 2
Parameter Descriptions
Elect DR
dr:53.53.53.21
bdr:53.53.53.6
GigabitEthernet 2
debug ip ospf packet
This command debugs received and transmitted OSPF packets. As with all XSR debug
commands, it is set to privilege level 15 by default.
Syntax
debug ip ospf packet
5-104 Configuring the Internet Protocol
Note: This command does not display in running config because it is a debug function. It must be
set manually every time the XSR is rebooted.
OSPF DR Election.
Designated router.
Backup Designated router.
Interface on which the designated router resides.
Note: This command does not display in running config because it is a debug function. It must be
set manually every time the XSR is rebooted.