Enterasys X-Pedition XSR CLI Cli Reference Manual page 469

Examples
The following example configures two data streams on leased‐line BRI interface 1/1 at 56 kbps
with PPP encapsulation:
XSR(config)#interface bri 1/1
XSR(config-if<BRI-1/1>)#leased-line 56
XSR(config)#interface bri 1/1:1
XSR(config-if<BRI-1/1:1>)#ip address 1.1.1.2 255.255.255.0
XSR(config-if<BRI-1/1:1>)#encapsulation ppp
The following example configures BRI B‐channel 2:
XSR(config)#interface bri 1/1:2
XSR(config-if<BRI-1/1:2>)#ip address 1.1.1.3 255.255.255.0
XSR(config-if<BRI-1/1:2>)#encapsulation frame-relay
The following example configures one data stream on leased‐line BRI interface 1/1 at 112 kbps
with Frame Relay encapsulation:
XSR(config)#interface bri 1/1
XSR(config-if<BRI-1/1>)#leased-line 112
XSR(config)#interface bri 0/1/2:1
XSR(config-if<BRI-1/2:1>)#ip address 1.1.1.3 255.255.255.0
XSR(config-if<BRI-1/2:1>)#encapsulation frame-relay
pri-group
This command configures a T1/E1 port to ISDN PRI on a channelized E1/T1 card. All 23 T1 or 30
E1 time slots are assigned to ISDN control.
Syntax
pri-group
Syntax of the "no" Form
The no form of this command deregisters the T1/E1 controller from the ISDN controller. Use the no
form to remove the ISDN PRI and restore the T1/E1 controller to its default mode:
no pri-group
Mode
Controller configuration:
Example
The following NFAS example configures PRI with D‐channel backup:
XSR(config)#controller t1 1/0
XSR(config-controller<T1-1/0>)#pri-group
XSR(config-controller<T/Exx>)#
ISDN Commands
Book Title goes here 11-91