Enterasys X-Pedition XSR CLI Cli Reference Manual page 330

BGP Debug Commands
Display Parameters
BGP
Rx Update
Tx Update
Nbr
w/ attr
Origin
AS_SEQ Path
Next Hop
Med
Rx NLRI
Prefix
Len
Tx NLRI
show ip traffic
This command display BGP statistics among other IP data.
Syntax
show ip traffic
Mode
EXEC configuration:
Example
The following sample outputdisplays only BGP‐specific data:
XSR#show ip traffic
BGP Statistics:
Rcvd:
Sent:
6-134 Configuring the Border Gateway Protocol
Debug event generated by the BGP process.
Update message has been received.
Update message being transmitted.
Neighbor IP address.
Path Attributes in the update message.
Origin of the path.
AS Sequence Path list.
Next Hop IP address.
Multi‐exit discriminator.
Received Network Layer reachability information.
Network IP address.
Length of prefix mask.
Transmitted Network Layer reachability information.
XSR>
184 total
3 opens, 0 notifications, 4 updates
177 keepalives, 0 route-refresh
186 total
4 opens, 0 notifications, 6 updates
176 keepalives, 0 route-refresh