Table of Contents
Advertisement
1.1
CONNECTIVITY
The module connects to Ethernet networks or workstations through the front panel connectors. The
ports are IEEE 802.3 100BASE-FX compliant, using MT-RJ fiber connectors for multimode fiber.
1.2
RUNTIME IP ADDRESS DISCOVERY
This feature enables the module to automatically accept an IP address from a Boot Strap Protocol
(BootP) server on the network without requiring a user to enter an IP address through Local
Management.
When the module is connected to the network and powered up, Runtime IP Address Discovery
(RAD) checks the module for an IP address. If one has not yet been assigned (module IP address
set to 0.0.0.0), RAD checks to see if any of the module interfaces have a link. If a link is
discovered, RAD sends out Reverse Address Resolution Protocol (RARP) and BootP requests to
obtain an IP address from a BootP server on the network.
The RAD requests start at an interval of one per second. The interval then doubles after every
transmission until an interval of 300 seconds is reached. At this point, the interval remains at 300
seconds. The RAD requests continue until an IP address is received from a RARP or BootP server,
or an IP address is entered using Local Management.
NOTE: The module will reboot after RAD is successful.
1.3
HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION
The fixed front panel ports on the module have the ability to auto-negotiate the ports' mode of
operation (half-duplex or full-duplex) between two devices according to the 802.3x standard.
During Auto-Negotiation, two devices automatically exchange information "telling" each other
their current operating mode. The Auto-Negotiation feature targets the maximum capability that
can be reached between the two devices. For example, the module can adjust to full-duplex
operation when the device on the other end of the connection can also adjust from half-duplex to
full-duplex. If the device on the other end of the connection can only operate in half-duplex mode,
then the module simply adjusts to operate in half-duplex mode.
Connectivity
Introduction
1-3
Advertisement
Table of Contents
Troubleshooting
