Table of Contents
Advertisement
Syntax of the "no" Form
The no form of this command removes the static RP configuration:
no ip pim rp-address rp-address
Mode
Global configuration:
Example
This example configures the RP used by the multicast groups within the range 225.1.1.0/24:
XSR(config)#access-list 2 permit 225.1.1.0 0.0.0.255
XSR(config)#ip pim rp-address 192.168.2.5
ip pim rp-candidate
This command sets the XSR to advertise itself as a PIM candidate Rendezvous Point (RP) to the
BSR. Only one candidate RP can be configured per box.
Syntax
ip pim rp-candidate type number [group-list access-list][priority priority-value]
type number
access-list
priority
priority-value
Syntax of the "no" Form
The no form of this command removes this XSR as an RP candidate:
no ip pim rp-candidate
Mode
Global configuration:
Defaults
•
The XSR is not configured as an RP candidate.
•
DR priority is 192 by default if it becomes one.
Example
This example sets the XSR to advertise itself as a candidate RP to the BSR in its PIM domain:
XSR(config)#interface FastEthernet 1
XSR(config)#ip pim rp-candidate FastEthernet 1
XSR(config)#
Interface whose IP address is advertised as a candidate RP address.
Standard IP access list number that defines the group prefixes that are
advertised in association with the RP address.
The priority of this candidate RP.
Priority value, ranging from 0 to 255.
XSR(config)#
PIM Commands
XSR CLI Reference Guide 7-93
Advertisement
Table of Contents
