Observing Syntax and Conventions
The CLI command syntax and conventions use the notation described below.
Convention
xyz
[x]
[x | y | z]
{x | y | z}
[x {y | z} ]
(config-if<xx>)
Next Mode entries display the CLI prompt after a command is entered.
Sub-command
soho.enterasys.com
ADSL Configuration Commands
The following command sets define ADSL functionality on the XSR including:
•
"CMV Commands" on page 13‐83.
•
"Other ADSL Commands" on page 13‐87.
•
"PPP Configuration Commands" on page 13‐99.
•
"ATM Clear and Show Commands" on page 13‐103.
CMV Commands
cmv append
This command adds a Command Management Variable (CMV) to the DSP training list which is
used by the DSP firmware when the line is in training mode. This command is intended for use by
Enterasys field service personnel only. This command requires that the ADSL NIM be installed
and the DSP firmware file be present in the
Description
Key word or mandatory parameters (bold)
[ ] Square brackets indicate an optional parameter (italic)
[ | ] Square brackets with vertical bar indicate a choice of values
{ | } Braces with vertical bar indicate a choice of a required value
[{ | } ] Combination of square brackets with braces and vertical bars indicates a
required choice of an optional parameter
xx signifies interface type and number, e.g.: F1, S2/1.0, D1, M57, L1,
ATM0/1/1
headings are displayed in red, italicized text.
Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis
Configuring ADSL
directory.
Flash:
13
XSR CLI Reference Guide 13-83