Enterasys X-Pedition XSR CLI Cli Reference Manual page 248

IP Clear and Show Commands
Internet address is 58.58.58.1, subnet mask is 255.255.255.0 Secondary
Rcvd: 515027 octets, 3306 unicast packets,
Sent: 363256 octets, 2472 unicast packets,
MTU is 1500 bytes.
Helper address is not set.
Directed broadcast is enabled.
Outgoing access list is not set.
Inbound access list is not set.
Router discovery is disabled.
The following is sample output from a VLAN interface on FastEthernet sub‐interface 2.1:
XSR#show ip interface FastEthernet 2.1
FastEthernet2.1 is Admin Up
Internet address is 1.2.3.4, subnet mask is 255.255.255.0
Rcvd: 956984 octets, 11 unicast packets,
Sent: 494708 octets, 6789 unicast packets,
MTU is 1500 bytes.
Proxy ARP is enabled.
Helper address is not set.
Directed broadcast is enabled.
Outgoing access list is not set.
Inbound access list is not set.
Router discovery is disabled.
IP Policy Based Routing is not enabled.
Parameter Description
FastEthernet 1 is
Admin Up
Last change
Octets
Unicast packets
Discards
Errors
Unknown protocol
MTU
Proxy ARP
Helper address
Directed broadcast
forwarding
Outgoing access list
5-172 Configuring the Internet Protocol
0 discards, 0 errors, 0 unknown protocol.
0 discards, 0 errors.
0 discards, 0 errors, 0 unknown protocol.
0 discards, 0 errors.
This refers to Layer 3 state for this interface. Valid states are Up and Down.
The value of system time when the interface entered the current
operational state. If the current state was entered prior to the last re‐
initialization of the local network management subsystem, then this is 0.
Sum of octets received/sent through the specified interface.
Sum of unicast packets received/sent through the port.
Sum of packets discarded even if no error had been detected, but for
internal reasons (for instance to free up some buffer space).
Sum of packets discarded because of errors.
Sum of packets discarded because of unknown or unsupported protocol.
Shows the MTU value set on the interface.
Shows whether proxy ARP is enabled or disabled.
Helper address if one has been set.
Indicates whether directed broadcast forwarding is enabled.
Indicates whether the interface has an outgoing access list set.