Enterasys X-Pedition XSR CLI Cli Reference Manual page 197

Sample Output
The following are sample responses:
XSR#show ip ospf neighbor
ID
10.7.7.1
10.0.0.1
XSR#show ip ospf neighbor detail
Neighbor 10.7.7.1 interface address 10.5.6.1
In the area 0.0.0.0 via FastEthernet6
Neighbor priority is 1, state is FULL.
Options 1
Dead interval is 40 sec(s)
Link state retransmission interval is 5 sec(s)
Neighbor 10.0.0.1, interface address 10.1.1.1
In the area 0.0.0.0 via FastEthernet3
Neighbor priority is 1, State is FULL
Options 1
Dead interval is 40 sec(s)
Link state retransmission interval is 5 sec(s)
Parameter Description
ID
Pri
State
Dead Intvl
Address
Interface
In the area
Options
show ip ospf virtual-links
This command displays data about virtual links configured on a router.
Syntax
show ip ospf virtual-links
Mode
EXEC or Global configuration:
Pri State Dead Intvl
1 FULL 40
1 FULL 40
Router ID of the neighbor.
Priority of the neighbor over this interface.
OSPF communication state with followed by the interface status of the neighbor.
Interval this router will wait without receiving a Hello packet from a neighbor
before declaring a neighbor as being down.
IP address of the neighbor over the interface (see next field).
Interface of this router over which it has neighbors identified by the neighbor ID.
Area over which this router is a neighbor.
Decimal equivalent of the E‐bit from the options field. 0 indicates the area is a stub
area, 2 indicates the area is capable of accepting external LSAs (not a stub).
XSR>
Address
10.5.6.1
10.1.1.1
or XSR(config)#
OSPF Debug and Show Commands
Address
FastEthernet6
FastEthernet3
XSR CLI Reference Guide 5-121