Enterasys X-Pedition XSR CLI Cli Reference Manual page 372

PPP Debug, Clear and Show Commands
Mode
EXEC or Global configuration:
Sample Output
The following output is produced by this command:
Serial 1/0 is Admin Up / Oper Up
Internet address is 25.25.25.3, subnet mask is 255.255.255.0
LCP
IPCP
Multilink State: OPENED
show ppp interface
This command displays all configured PPP instances, the interface they belong to and their status.
To issue this command correctly, follow the guidelines below:
• Issuing the
statistics and configuration for all interfaces running PPP.
• The
interface type running PPP.
• The
configuration for the interface type number.
• The
Dialer statistics with Serial and Multiclass options.
• The
command displays multilink statistics with various options.
Syntax
show ppp interface card/port [type number options]
card/port
type
number
option
The Serial port card, port, sub‐interface, and channel numbers are expressed as follows:
0
<1-2>/<0-3>
<1-2>/<0-3>.<1-30>
<1-2>/<0-3>:<0-31>
<1-2>/<0-3>:<0-31>.<1-30>
8-102 Configuring the Point-to-Point Protocol
State: OPENED
State: OPENED
show ppp interface
show ppp interface
show ppp interface
show ppp interface
show ppp interface
The NIM number and PPP WAN port:channel number to view associated link
status, statistics and settings.
The interface type PPP is running on including: Dialer (0 to 255), Multilink (1 to
32767), or Serial (see below).
Card/port numbers or Card/port:channel number.
memberlink, mlpppgroup (MLPPP only), multi‐class, or bap (MLPPP only)
statistics.
XSR> XSR(config)#
or
command without any other parameter displays link status,
type command displays link status, statistics and settings for any
type number
command displays link status, statistics and
dialer number [multi-class serial]
multilink number [bap | memberlink | multi-class]
Console port.
Card and port number.
Card, port, sub‐interface number.
Card, port and channel number.
Card, port, channel and sub‐interface number
command displays