Enterasys X-Pedition XSR CLI Cli Reference Manual page 71

Mode
Controller configuration:
Default
• T3: 44,210 kbps (full‐rate)
• E3: 34,099.5 kbps (full‐rate)
Example
The following example configures the T3 controller in slot 1, card 2 with line source clocking, M13
framing, in unchannelized mode, with a cable length of 250, DSU interoperability mode set to a
Kentrox DSU, and a DSU bandwidth of 44,210 kbps:
XSR(config)#controller t3 1/2/0
XSR(config-controller<T3-1/2/0>)#no channelized
XSR(config-controller<T3-1/2/0>)#clock source line
XSR(config-controller<T3-1/2/0>)#framing m13
XSR(config-controller<T3-1/2/0>)#cablelength 250
XSR(config-controller<T3-1/2/0>)#dsu mode 1
XSR(config-controller<T3-1/2/0>)#dsu bandwidth 44210
e-bit-reset
This command sets the E‐bit in the E1 frame to zero while the port is in an asynchronous state.
Syntax
e-bit-reset
Syntax of the "no" Form
The no form of this command negates the E‐‐bit reset:
no e-bit-reset
Mode
Controller configuration:
Example
The following example resets the E‐bit on the E1 controller:
XSR(config-controller<E1-1/2/0>)#
XSR(config-controller xx)#
XSR(config-controller)#
T1/E1 & T3/E3 Commands
XSR CLI Reference Guide 2-65