Enterasys X-Pedition XSR CLI Cli Reference Manual page 434

Frame Relay Clear and Show Commands
Serial 1/0, CIR= 64000, Bc=8000, BE= 9000, fragment=53
Adaptive Shaping: Disabled, Service Policy: Voice
# FR Ports = 1, # FR sub-Interfaces = 3, # DLCIs = 7
show interface serial
The following statistics are added to the command if the port is configured for Frame Relay.
Sample Output
The following example displays T1 statistics:
XSR#show interface serial 2/0:1
********** Serial Interface Stats **********
Serial 2/0:1 is Admin Up
Internet address is not assigned
Frame Relay Port Statistics:
Line Protocol = UP
Encapsulation FRAME-RELAY IETF,
Num PVCs = 1, Total LMI Tx = 0, LMI Rx = 0
TX:
RX:
Approximate Speed = 128 Kbps
Sub Interface 1
The following example displays Serial interface 2/0 statistics:
********** Serial Interface Stats **********
Serial 2/0 is Admin Up
Internet address is 10.10.11.30, subnet mask is 255.255.255.0
Frame Relay Port Statistics:
Line Protocol = UP
Encapsulation FRAME-RELAY IETF,
Num PVCs = 2, Total LMI Tx = 10, LMI Rx = 0
TX:
RX:
Approximate Speed = 65 Kbps
Sub Interface 1
State = UP,
Configured DLCIs:
16
Sub Interface 2
State = UP,
Configured DLCIs:
150
The name of this device is Ser2/0.
9-110 Configuring Frame Relay
Packets = 18155, Bytes = 20214344 PPS = 0
Packets = 18154, Bytes = 20214072 PPS = 0
State = UP, Num Stations = 1
Configured DLCIs: 16, 18, 22
Packets = 10, Bytes = 133
Packets = 0, Bytes = 0
Num Stations = 1
Num Stations = 1
FRAME-RELAY DTE,
Discarded Packets TX/RX = 0/0
FRAME-RELAY DTE,
PPS = 0
PPS = 0
Discarded Packets TX/RX = 0/0
LMI = NONE
LMI = NONE