Enterasys X-Pedition XSR CLI Cli Reference Manual page 175

ip ospf transmit-delay
This command sets the interval required to transmit a link state update packet on this interface.
Syntax
ip ospf transmit-delay seconds
seconds
Syntax of the "no" Form
The no form of this command sets the value to the default.
no ip ospf transmit-delay
Mode
Interface configuration:
Default
1 second
Example
The following example sets the interval required to transmit a link state update packet on interface
FastEthernet 1 at 20 seconds:
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#ip address 172.16.16.1 255.255.255.0
XSR(config-if<F1>)#ip ospf transmit-delay 20
network
This command identifies and defines area IDs for interfaces OSPF runs on.
Syntax
network address wildcard-mask area area-id
address
wildcard-mask
area-id
Syntax of the "no" Form
The no form of this command removes OSPF routing for interfaces identified by the address and
wildcard‐mask parameters:
no network address wildcard-mask area area-id
Specifies the transmit delay, ranging from 1 to 3600 seconds.
XSR(config-if<xx>)#
IP address of a specific interface or a group of interfaces as a function of
the wild‐card mask.
Inverted mask that begins with 0s and end with 1s. The most specific
format is 0.0.0.0, which matches one address. The least specific is
255.255.255.255 matching any address.
Specifies the area‐id that the OSPF address range is linked to. Valid
values are decimal values or IP addresses.
OSPF Commands
XSR CLI Reference Guide 5-99