Enterasys X-Pedition XSR CLI Cli Reference Manual page 511

Syntax
cmv cr command-ID offset
command-ID
offset
Mode
ATM Interface configuration:
Example
The following example reads CMV STAT 0 from the DSP:
XSR(config-if<ATM0/1/1>)#cmv cr STAT 0
cmv cw
This command writes a Command Management Variable (CMV) to the DSP. This command is
intended for use by Enterasys field service personnel only.
This command requires that the ADSL NIM be installed and the DSP firmware file be present in
the Flash:
Syntax
cmv cw command-ID offset value
command-ID
offset
value
Mode
ATM Interface configuration:
Example
The following example writes UOPT 2 with a hex value to the DSP:
XSR(config-if<ATM0/1/1>)#cmv cw UOPT 2 0x0c0e1014
cmv delete
This command deletes the specified Command Management Variable (CMV) from the DSP
retaining list which is used by the DSP firmware when the line is in training mode. This command
is intended for use by Enterasys field service personnel only.
This command requires that the ADSL NIM be installed and the DSP firmware file be present in
the Flash:
Represents a 4‐character CMV command.
Decimal or hexadecimal number representing where to read the value.
XSR(config-if<ATMxx>)#
directory.
Represents a 4‐character CMV command.
Decimal or hexadecimal number representing where to write the value.
Decimal or hexadecimal number.
XSR(config-if<ATMxx>)#
directory.
CMV Commands
XSR CLI Reference Guide 13-85