Enterasys X-Pedition XSR CLI Cli Reference Manual page 510

CMV Commands
Syntax
cmv append command-ID offset value
command-ID
offset
value
Mode
ATM Interface configuration:
Example
The following example adds the CMV DOPT 1 with a hex value:
XSR(config-if<ATM0/1/1>)#cmv append DOPT 1 0x306090c0
cmv clear
This command removes all Command Management Variable (CMV) commands from the CMV
training list which is used by the DSP firmware when the line is in training mode. This command
is intended for use by Enterasys field service personnel only.
This command requires that the ADSL NIM be installed and the DSP firmware file be present in
the Flash:
Syntax
cmv clear
Mode
ATM Interface configuration:
Example
The following example deletes all CMVs from the training list:
XSR(config-if<ATM0/1/1>)#cmv clear
cmv cr
This command reads a Command Management Variable (CMV) from the DSP. This command is
intended for use by Enterasys field service personnel only.
This command requires that the ADSL NIM be installed and the DSP firmware file be present in
Flash:
the
13-84 Configuring ADSL
Represents a 4‐character CMV command.
Decimal or hexadecimal number representing where to write the value.
Decimal or hexadecimal number.
XSR(config-if<ATMxx>)#
directory.
XSR(config-if<ATMxx>)#
directory.