Table of Contents
Advertisement
Observing Syntax and Conventions
The CLI command syntax and conventions use the notation described in the following table.
Convention
xyz
[x]
[x | y | z]
{x | y | z}
[x {y | z} ]
(config-if<xx>)
Next Mode entries display the CLI prompt after a command is entered.
soho.enterasys.com
Hardware Controller Commands
The following command sets allow you to define synchronization features for the XSR:
•
"Hardware Controller Commands" on page 4‐83
•
"Hardware Controller Clear and Show Commands" on page 4‐92
clock rate
This command configures the clock rate for the hardware connections on a serial interface. The
command is valid and takes effect only when the interface is running in Asynchronous mode. For
Synchronous mode, the clock rate is received externally.
Configuring Hardware Controllers
Description
Key word or mandatory parameters (bold)
[ ] Square brackets indicate an optional parameter (italic)
[ | ] Square brackets with vertical bar indicate a choice of values
{ | } Braces with vertical bar indicate a choice of a required value
[{ | } ] Combination of square brackets with braces and vertical bars indicates
a required choice of an optional parameter
xx signifies interface type and number, e.g.: F1, S2/1.0, D1, M57, G3. F
indicates a FastEthernet, and G a GigabitEthernet interface.
Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis
Note: The clock rate cannot be changed in loopback mode.
4
XSR CLI Reference Guide 4-83
Advertisement
Table of Contents
