Table of Contents
Advertisement
RX RING:
The secondary MAC addresses are (in hex):
show controllers serial
This command displays detailed serial controller data for an interface.
Syntax
show controller serial card/port
card
port
Mode
Privileged EXEC or Global configuration:
Sample Output
The following example displays output from Serial port 1/0:
XSR#show controllers serial 1/0
Forward Engine Serial Layer Tx/Rx Stats:
RX FROM UPPER LAYER & TX TO DRIVER
RX FROM DRIVER & TX TO UPPER LAYER
datalen 0x00000000, status 0x00000000, buffer 0x80000000
datalen 0x00000000, status 0x00000000, buffer 0x80000000
datalen 0x00000000, status 0x00000000, buffer 0x80000000
datalen 0x00000000, status 0x00000000, buffer 0x80000000
datalen 0x00000000, status 0x00000000, buffer 0x80000000
[...]
Ring starts at 0x81568c60.
RMaxDR=512, pRCurrDR=0x00000830, RIdx=0
datalen 0x00000000, status 0x00000000, buffer 0x8ff5df60
datalen 0x00000000, status 0x00000000, buffer 0x8ff5e620
datalen 0x00000000, status 0x00000000, buffer 0x8fe86ce0
datalen 0x00000000, status 0x00000000, buffer 0x8fe873a0
datalen 0x00000000, status 0x00000000, buffer 0x8fe87a60
[...]
[0] : < not used >
[1] : < not used >
[2] : < not used >
[3] : < not used >
XSR card number of the serial controller.
XSR port number of the serial controller.
Pcks Rx
= 0
Pcks Tx
= 0
Pcks Discarded = 0
Pcks Rx
= 0
Pcks Tx
= 0
Pcks Discarded = 0
Hardware Controller Clear and Show Commands
XSR#
XSR(config)#
or
XSR CLI Reference Guide 4-97
Advertisement
Table of Contents
