Table of Contents
Advertisement
Mode
Interface configuration:
Examples
The following example enables preempt for virtual router group 1 with a 2‐second delay set on F1:
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#vrrp 1 preempt delay 2 or vrrp preempt delay 2
The following example disables the preempt for VR group 1 on F1:
XSR(config-if<F1>)#no vrrp 1 preempt or no vrrp preempt
vrrp <group> priority
This command sets the priority level of the router within a virtual group. Use it to control which
router becomes the master VR.
Syntax
vrrp group priority level
group
level
Syntax of the "no" Form
The no form of this command restores the default value:
no vrrp group priority
Defaults
•
Level: The priority of the IP address owner is 255, otherwise the default is 100.
•
Group: 1 , ranging from 1 to 255
Mode
Interface configuration:
Examples
This example sets priority 150 for VR group 1 on F1:
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#vrrp 1 priority 150 or vrrp priority 150
The following example sets priority to default for VR group 1 on F1:
XSR(config-if<F1>)#no vrrp 1 priority
XSR(config-if<xx>)#
VR group number.
Priority of the router within the VRRP group. Range: 1 to 254.
XSR(config-if<xx>)#
Virtual Router Redundancy Protocol Commands
or no vrrp priority
XSR CLI Reference Guide 5-195
Advertisement
Table of Contents
