•
backup
‐ configures and enables a backup interface for the ATM sub‐interface. Refer to page
13‐90 for the command description.
crypto
•
‐ enables and configures VPN parameters on the sub‐interface. Refer to page 13‐92 for
the command description.
•
description
for the command description.
encapsulation
•
page 13‐92 for the command description.
•
exit
‐ quits ATM Sub‐Interface mode and returns to Global mode. Refer to page 13‐93 for the
command description.
ip address
•
the IP address and subnet mask be negotiated. Refer to page 13‐93 for the command
description.
•
no shutdown
virtual circuit. Refer to page 13‐94 for the command description.
oam-pvc
•
‐ enables end‐to‐end F5 (circuit) OAM cell procedures for ATM Permanent Virtual
Circuit (PVC) management. Refer to page 13‐95 for the command description.
•
oam-retry
‐ configures parameters related to OAM cell handling for ATM VC management.
Refer to page 13‐96 for the command description.
pvc
•
‐ sets the sub‐interface circuit type to PVC and specifies ATM VPI/VCI values. Refer to
page 13‐96 for the command description.
•
shutdown
‐ sets the ATM sub‐interface to the administrative Down state halting all data traffic
on this VC. Refer to page 13‐97 for the command description.
Syntax
interface atm {slot/card/port.sub-interface}[point-to-point]
slot
card
port
sub-interface
point-to-point
Syntax of the "no" Form
The no form of this command deletes the sub‐interface object:
no interface atm [slot/]card/port.sub-interface [point-to-point]
Mode
Global configuration:
Next Mode
ATM Sub‐Interface configuration:
‐ adds a description string to an existing ATM sub‐interface. Refer to page 13‐92
‐ selects the data encapsulation method for this ATM sub‐interface. Refer to
‐ specifies the IP address and subnet mask of the ATM sub‐interface or requests
‐ sets the ATM sub‐interface to the administrative up state and enables the
The XSR slot number, ranging from 0 to 2.
The XSR NIM number, ranging from 1 to 2.
The XSR slot number: 0.
Identifies a sub‐interface on that interface, ranging from 1 to 30.
Interoperability option.
XSR(config)#
XSR(config-if<ATMxx.x>)#
Other ADSL Commands
XSR CLI Reference Guide 13-89