Table of Contents
Advertisement
****************** REMOTE AUTO INSTALL TERMINATING*****************
+
The RAI process is complete and is preoceding to system initialization where it will process the new
config
file.
Configuring RAI for DHCP over LAN
The following example configures DHCP server to be used with RAI over Ethernet. Note that
there is no need for a DNS server because the
server. Begin by creating an IP local pool which will include the Fast/GigabitEthernet interface
address:
XSR(config)#ip local pool dhcp 200.1.0.0 255.255.255.0l
Next, configure the interface that will service the remote device, set the IP address inside the pool
defined earlier, and enable DHCP Server:
XSR(config)#interface GigabitEthernet 2
XSR(config-if<G2>)#ip address 200.1.0.4 255.255.255.0
XSR(config-if<G2>)#ip dhcp server
XSR(config-if<G2>)#no shutdown
Now configure the following DHCP Client parameters:
XSR(config)#ip dhcp pool dhcp
XSR(config-dhcp-pool)#lease 0 0 10
+
This command sets a lease interval of 10 minutes
XSR(config-dhcp-pool)#hardware-address 0001.f412.2334
+
This command sets the MAC address of the client
XSR(config-dhcp-pool)#host 200.1.0.66 255.255.255.0
+
This command binds 200.1.0.66/24 to the earlier configured hardware address
XSR(config-dhcp-pool)#option 12 instance 0 ascii etr1
+
This command sets the Client hostname as etr1
XSR(config-dhcp-pool)#option 150 instance 0 ip 1.1.1.1
+
This command configures the TFTP server IP address to 1.1.1.1
XSR(config-dhcp-pool)#option 67 instance 0 ascii etr1-startup-confg
+
This command enters the config-file name as startup-config
Remember to save your configuration after all edits.
Configuring RAI over ADSL
In the following example, a remote XSR is connected to an ADSL network at the central site with a
PPPoE server. A TFTP server runs on a separate machine - 192.168.72.118, while the PPPoE server
runs on a CISCO router. The PPPoE server can reside on any other device providing PPPoE
session termination and has a mechanism to direct TFTP broadcast packets to a specific IP
address. A DNS server is not required with this method because RAI over ADSL uses the serial
number of the XSR for the
The following is a CISCO configuration at the the central site:
vpdn enable
+
Enables a virtual private dial-up network configuration on the router.
vpdn-group 1
+
Creates a VPDN session group and links it to a virtual template.
accept-dialin
protocol pppoe
startup-config
startup-config
name.
Optional: Configuring Remote Auto Install
startup-
name is provided by the DHCP
XSR Getting Started Guide 3-5
Advertisement
Table of Contents
