Management; Switch Configuration Using Webview; Switch Configuration Using Cli Commands; Standards Compatibility - Enterasys SecureStack A2 A2H124-24P Hardware Installation Manual

Management

Management
Management of the module can be either in‐band or out‐of‐band. In‐band remote
management is possible using Telnet, Enterasys Networks' NetSight
application, or the WebView application. Out‐of‐band management is provided through
the DB9 Console port connector on the front panel using a VT100 terminal or a VT100
terminal emulator.

Switch Configuration Using WebView

Enterasys Networks' HTTP‐based Web management application (WebView) is an
intuitive web tool for simple management tasks.

Switch Configuration Using CLI Commands

The CLI commands enable you to perform more complete SecureStack A2 configuration
management tasks.
For CLI command set information and how to configure the module, refer to the
SecureStack A2 Configuration Guide.

Standards Compatibility

The 100BASE‐T ports are compliant with the following standards and operations:
• IEEE 802.3
• IEEE 802.3u
• IEEE 802.3ab (Stack Ports)
• IEEE 802.3ad
• IEEE 802.3af
• Full‐Duplex operation
In addition to the above standards, the SFP ports are compliant with the following
standards and operations:
• IEEE 802.3z
• IEEE 802.3x Flow Control support for Full‐Duplex mode
• Auto‐negotiation for Full‐Duplex control operations
1-6 Introduction
®
management