Zone Type - Fire-Lite MS-9200UDLS Manual

Programming
ZONE SETUP
1=ZONE TYPES
2=ZONES AVAILABLE
3=ZONE MESSAGE
Zone Setup Screen #3
ZONE TYPE PROG
1=MONITOR
2=SMOKE PHOTO
3=WATERFLOW
ZONE TYPE PROG
1=MEDICAL
2=HAZARD
3=TAMPER
96

Zone Type

Zone Types must be programmed only if a DACT, programmed for zone reporting, is installed on
the control panel. Pressing 1 for Zone Types, while viewing Zone Setup Screen #3, will display a
screen similar to the following:
1=Z00
2=Z01
3=Z02
This display will show the system zones (default and user programmed) and their associated types.
Note that an up and/or down arrow will appear in the upper right corner of the display, indicating
that additional screens of zone information exists. Press the up or down arrow keys to view zones
Z00 through Z99.
Zone types can be changed by pressing the keypad number key corresponding to the zone in each
Zones Installed Screen. Available zone types will be displayed in the resultant screens. For
example, to change the zone type for zone Z02 in the screen illustrated above, press 3. The
following screens will be displayed:
Zone Type Program Screen #1
Zone Type Program Screen #3
To change the zone type for Z02 to Pull Station, scroll the display until Zone Type Program Screen
#2 is displayed. Press 2 to program zone Z02 as a Pull Station zone. The display will return to the
Zones Installed Screen showing zone Z02 and the Pull Station program type. Repeat the procedure
for each zone to be changed.
IMPORTANT! In Zone Type Program Screen #1, selecting WATERFLOW will assign a Waterflow
silenceable zone type to the selected zone. Any signaling devices programmed to the same zone can
be silenced by pressing the Alarm Silence key or by using the auto-silence feature.
To program a waterflow circuit as nonsilenceable, refer to "System Setup" on page 98.
NOTE: Zone Types are only relevant for Central Station reporting. Changing a zone type will
only change how it is reported to the Central Station.
ZONE TYPE PROG
MONITOR
MONITOR
MONITOR
Zones Installed Screen
ZONE TYPE PROG
1=HEAT
2=PULL STATION
3=DUCT
ZONE TYPE PROG
1=SUPERVISORY
2=PROC. MON
3=SMOKE ION
MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
Master Programming Level
Zone Type Program Screen #2
Zone Type Program Screen #4