2: Battery Power; 3: Special Application Dc Power Output Connection - Fire-Lite MS-9200UDLS Manual

Installation
2.3.2 Battery Power
The batteries must be sealed lead acid type. Before con-
necting the batteries to the FACP, make certain that the
interconnect cable between the batteries is not connected.
Do not connect the interconnect cable until the system is
completely installed. Observe polarity when connecting
the batteries. Connect the battery cable to J9 on the main
circuit board. Refer to "Power Supply Calculations" on
page 189, for calculation of the correct battery rating.
WARNING: RISK OF PERSONAL INJURY
!
BATTERY CONTAINS SULFURIC ACID WHICH CAN CAUSE SEVERE BURNS TO THE SKIN
AND EYES AND CAN DESTROY FABRICS. IF CONTACT IS MADE WITH SULFURIC ACID,
IMMEDIATELY FLUSH THE SKIN OR EYES WITH WATER FOR 15 MINUTES AND SEEK
IMMEDIATE MEDICAL ATTENTION.
2.3.3 Special Application DC Power Output Connection
All Special Application DC power outputs are power-limited (refer to"UL Power-limited Wiring
Requirements" on page 54).
Power-limited Non-resettable or Resettable Power
1.0 amperes max., 24 VDC nominal filtered, non-
resettable or resettable power can be drawn from TB1
Terminals 1(+) and 2(-)
JP4 is used to configure TB1,
Terminals 1 & 2 for:
• Resettable Power - jumper pins
2 & 3 of JP4
• Nonresettable Power - jumper
pins 1 & 2 of JP4 as shown
Figure 2.6 Special Application Power Outputs - 24 VDC
50
Power-limited Resettable or Non-resettable Power
1.0 amperes max., 24 VDC nominal filtered, resettable or
non-resettable power can be drawn from TB1 Terminals
3(+) and 4(-)
+ - + -
TB1
1 2 3 4
+ 24V - + 24V -
NON-RST RST
POWER POWER
JP6
1
JP4
2
3
3
2
1
MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
Interconnect
Cable
+
-
-
+
JP6 is used to configure TB1,
Terminals 3 & 4 for:
• Resettable Power - jumper pins 2
& 3 of JP4
• Nonresettable Power - jumper
pins 1 & 2 of JP4 as shown
Power