Fire-Lite MS-9200UDLS Manual page 118

Programming

Pressing 2 for ACS Options while viewing the Annunciators screen, will display the following
ANNUNCIATORS
1=TERM ENABLED
screen:
2=ACS OPTIONS
3=ANN-BUS OPTIONS
Annunciator Screen
Pressing 1 while viewing the ACS Options screen will cause the display to toggle between ACS
Enabled Yes and ACS Enabled No. To install an ACS annunciator, the display must read ACS
Enabled Yes.
If ACS has been enabled, press 2 while viewing the Annunciator Screen to select addresses for the
ACS annunciators. The following screen will be displayed:
Pressing the down arrow key will allow the programmer to view additional screens displaying
Addresses 1 -31. Each screen will indicate if an address has been used for an installed ACS
annunciator. To select one or more addresses for the installed ACS annunciator(s), press the
number key corresponding to the address in each screen. The display for the selected address will
change from No to Yes. Each press of the number key will cause the display to toggle between No
and Yes. The address of each installed annunciator must be enabled to allow communication
between the FACP and annunciator.
118
ACS Options
1=ACS ENABLED
2=ACS INSTALLED
1=ADDRESS 1
2=ADDRESS 2
3=ADDRESS 3
ACS OPTIONS
ANNUNCIATOR
ACS Installed Screen
MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
Master Programming Level
NO
YES
NO
NO