Programming
1=STANDARD ADJECTIVE
2=STANDARD NOUN
3=CUSTOM ADJECTIVE
4=CUSTOM NOUN
Noun/Adjective Screen
**********************
1=BASEMENT
2=BOILER RM
3=CLASSROOM
**********************
1=ELEVATOR
2=ENTRANCE
3=FLOOR
**********************
1=KITCHEN
2=LOBBY
3=OFFICE
**********************
1=STAIRWAY
2=STOREROOM
3=WING
84
Pressing 2 while viewing the Noun/Adjective Screen will cause the following screen(s) to be
displayed. Note that the keyboard down arrow key must be pressed to see all the Noun screens.
Press the number corresponding to the noun that is to be used as a descriptor for the location of the
monitor module currently being programmed.
Noun Screen #1
Noun Screen #3
Noun Screen #5
Noun Screen #7
Pressing 3 or 4 while viewing the Noun/Adjective Screen will display screens similar to the
previous Adjective and Noun Screens. The new screens will list Custom Adjectives and Nouns
which have been programmed into the control panel using the PS-Tools utility.
**********************
1=CLOSET
2=CORRIDOR
3=ELECTRIC RM
Noun Screen #2
**********************
1=GARAGE
2=HALLWAY
3=HVAC RM
Noun Screen #4
**********************
1=PATIENT
2=RESTROOM
3=ROOM
Noun Screen #6
**********************
1=ZONE
Noun Screen #8
MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
Master Programming Level