Fire-Lite MS-9200UDLS Manual page 28

Product Description
Opening/Closing Annunciator

The following procedure details the steps used to open the annunciator in order to access the termi-
nal block and DIP switches (refer to figure below):
1. Turn the key switch to the ON (Unlocked) position by turning the key counter-clockwise
2. Push in the snap latch located on the right side of the unit while pulling the cover open
3. To close the cover, make certain the key switch is in the ON (Unlocked) position. Swing the
cover closed, snapping it shut
4. Turn the key switch to the OFF (Locked) position by turning clockwise and remove the key
Annunciator cover
with LCD display
Mounting

The ANN-80 can be surface or semi-flush mounted to a single, double or 4" square electrical box.
Select and remove the appropriate knockout(s), pull the necessary wires through the knockouts and
mount the annunciator in or on the wall depending on the type of installation desired.
The ANN-SB80KIT(-R/-B/-W) is an available mounting kit for the ANN-80 annunciator. The kit
comes with a surface backbox and surface wedge for angled viewing. The two pieces can be used
separately or can be stacked together.
The ANN-80 cover must be attached to the annunciator backplate before mounting the annunciator
to the electrical box/wall. The cover cannot be reattached or removed after the annunciator has
been mounted.
Annunciator mounted on
surface wedge from the
28
Key switch shown in
OFF/Locked position
ANN-SB80KIT
Annunciator mounted on
surface backbox from the
ANN-SB80KIT
MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
Accessories
Annunciator backplate
Press in latch
and
Pull annunciator
cover open
Annunciator mounted on stacked
surface wedge and backbox from
the ANN-SB80KIT