Delete Detector; Edit Detector - Fire-Lite MS-9200UDLS Manual

Master Programming Level

Pressing 2 in the Detector Screen will display the Delete Detector Screen which allows the
DETECTOR
1=ADD programmer to delete a specific detector:
2=DELETE
3=EDIT
Detector Screen
A flashing cursor will appear in the position of the first asterisk to the left. The programmer keys in
the three digit detector address, such as 005. When the last digit is keyed-in, the following screen
will be displayed:
The programmer can continue deleting detectors by pressing the ESC key which will return the
display to the Delete Detector Screen.

The programmer can change a detectors existing or factory default programming by pressing 3 in
the Detector Screen. The following screen will be displayed:
A flashing cursor will appear in the position of the first asterisk to the left. The programmer keys in
the three digit detector address, such as 017.
When the last digit is keyed-in, if the selected address has not been added to programming, a screen
showing information about a device that is installed with a lower address, closest to the selected
address, will be displayed.
If no detectors have been installed on the loop, the following will be displayed:
MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010

Delete Detector

ENTER DETECTOR#
***
DETECTOR#
IS DELETED

Edit Detector

ENTER POINT ADDRESS
***
DELETE DETECTOR
Delete Detector Screen
DELETE DETECTOR
EDIT DETECTOR
Edit Detector Screen
NO DETECTOR
INSTALLED
Edit Detector Screen #1
005
Programming
67