Enable/Disable Module; Type - Fire-Lite MS-9200UDLS Manual

Master Programming Level
To change the programming for the displayed module, press the keyboard down arrow key to view
the following Edit Control screens:

Enable/Disable Module

EDIT CONTROL
1=ENABLED
To Enable or Disable the control module, press the 1 key while viewing the Edit Control Screen #2.

2=TYPE

3=SILENCEABLE Each press of the key will toggle the screen between Enabled Yes and Enabled No. If Enabled No
is selected, the module will not be polled by the control panel, preventing the module from
Edit Control Screen #2
activating its output devices. The control panel will indicate a system trouble condition and the
Disable LED will turn on if any devices are disabled.
EDIT CONTROL
1=ENABLED
Type
2=TYPE
3=SILENCEABLE
To select the type of control module being programmed, press the 2 key while viewing the Edit
Edit Control Screen #2
Control Screen #2. This will cause the control panel to display the following Control Type Screens.
Press the down arrow key to view additional screens and selections.
MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
EDIT CONTROL
1=ENABLED
2=TYPE CONTROL
3=SILENCEABLE
Edit Control Screen #2
EDIT CONTROL
1=WALKTEST
2=ZONE ASSIGNMENT
00 ** ** ** **
Edit Control Screen #3
EDIT CONTROL
1=NOUN/ADJECTIVE
2=DESCRIPTION
********************
Edit Control Screen #4
CONTROL TYPE
1=BLANK
2=BELL-CIRCUIT
3=HORN-CIRCUIT
Control Type Screen #1
Programming
YES
YES
YES
87