Zoneadd - HP StorageWorks 2/64 - Core Switch Command Reference Manual

This command changes the defined configuration. For the change to be preserved across switch reboots,
it must be saved to flash memory using the
appropriate zone configuration must be enabled using the
NOTE: Use this command to create a broadcast zone. This is a special zone used to specify those nodes
that can receive broadcast traffic. Broadcast traffic is usually meant for servers and not for storage
devices. This zone must be named broadcast. Only one broadcast zone can exist within a fabric. This
type of zone is hardware enforced; the switch controls data transfer to a port.
When security mode is enabled, this command can be issued only from the primary FCS switch.
Operands
The following operands are required:
zonename
member
Examples
To create three zones using a combination of port numbers and zone aliases:
switch:admin> zonecreate "Red_zone", "1,0; loop1"
switch:admin> zonecreate "Blue_zone", "1,1; array1; 1,2; array2"
switch:admin> zonecreate "Green_zone", "1,0; loop1; 1,2; array2"
See also

zoneAdd

zoneDelete
zoneRemove
zoneShow
752 Fabric OS commands
cfgSave
Specify the name of an existing zone, in quotation marks. This
operand is required.
Specify a member or list of members to be added, in quotation
marks, separated by semicolons. Valid values can be one or more of
the following:
• A switch domain and port area number pair; for example, 2,
20. View the area numbers for ports using the
command.
• Node or port WWN.
• QuickLoop AL_PA.
• Zone alias name.
command. For the change to become effective, an
command.
cfgEnable
switchShow