Agtcfgshow - HP StorageWorks 2/64 - Core Switch Command Reference Manual

agtCfgShow

Displays the SNMP agent configuration.
Synopsis
agtcfgshow
Availability
all users
Description
Use this command to display the configuration of the SNMP agent in the switch.
NOTE: On a dual-switch chassis, there is one SNMP agent per logical switch. This command is specific
to the logical switch you are logged in to.
The following information displays:
sysDescr
sysLocation
sysContact
authTrapsEnabled
There are six communities, respective trap recipients, and trap recipients supported by the agent. The first
three communities are for read-write (rw) access and the last three are for read-only (ro) access. The
default value for the trap recipient of each community is 0.0.0.0. The community string length ranges
from 2 to 16 characters. The default values for the community strings are:
• Community 1: Secret C0de
• Community 2: OrigEquipMfr
• Community 3: private
• Community 4: public
• Community 5: common
• Community 6: FibreChannel
For an SNMP management station to receive a trap generated by the agent, the administrator must
configure a trap recipient to correspond to the IP address of the management station. In addition, the trap
recipient must be able to pass the access control list (ACL) check.
32 Fabric OS commands
The system (switch) description. The default value is Fibre Channel Switch.
The location of the system. The default value is End User Premise.
The contact information for the system. The default value is Field Support.
See the HP StorageWorks Fabric OS 5.x MIB reference guide for detailed
sysDescr, sysLocation, and sysContact descriptions.
When enabled, the authentication trap, authenticationFailure, is
transmitted to a configured trap recipient in the event that the agent received
a protocol message that is not properly authenticated. In the context of
SNMPv1 and SNMPv2c, this means that a request contains a community
string that is not known to the agent. The default value for this parameter is
0 (disabled).