HP StorageWorks 2/64 - Core Switch Command Reference Manual page 242

-b
-n
-i
host
user
pfile
passwd
If no operand is specified, the operation becomes interactive and you are prompted for input.
Examples
To download the firmware to an HA switch:
242 Fabric OS commands
Specify this operand to activate autoreboot mode. After downloading
firmware, the system must be rebooted. If single-CP mode is enabled and
this operand is not specified, the user must issue the
manually to activate the downloaded image. If autoreboot mode is
enabled, the switch reboots automatically after the
command has been run.
Specify this operand to deactivate autocommit mode. By default, after
running this command and after the reboot, the switch performs a
command automatically. When this mode is disabled,
firmwareCommit
the user needs to issue the
replicate the downloaded image to both partitions of a CP.
Specify to activate incremental upgrade mode. By default, this command
installs all the packages in the pfile. When this mode is enabled, the names
of the packages in pfile are compared to those installed on the switch,
and only the packages whose names are different are installed.
Specify a host server name or IP address: for example, citadel or
"192.168.166.30". The pfile is downloaded from this host. If this
operand is not used, the pfile is considered to be accessible through a
local directory.
Specify a user name for FTP server access: for example, "jdoe". This user
name is used to gain access to the host. This operand can be omitted if
pfile is accessible through a local directory or if the FTP user ID is
anonymous.
Specify a fully qualified path and file name: for example,
/v5.0.1/release.plist. Absolute path names might be specified
using forward slash (/).
Specify a password. This operand can be omitted if pfile is accessible
through a local directory or if no password is required by the FTP server.
command manually to
firmwareCommit
command
reboot
firmwareDownload