HP StorageWorks 2/64 - Core Switch Command Reference Manual page 494
Hp storageworks fabric os 5.x command reference guide (aa-rvhvb-te, september 2005)
Hide thumbs
Also See for StorageWorks 2/64 - Core Switch:
- Reference manual (278 pages) ,
- Installation manual (166 pages) ,
- Administrator's manual (152 pages)
Table of Contents
Advertisement
LIP reason
Speed Negotiation States
INIT
NM
WS
NF
NC
For a full explanation of the information displayed by this command, see the HP StorageWorks Fabric OS
5.x procedures user guide.
Operands
This command has the followingoptional Soperands:
count
saved
portid
494 Fabric OS commands
LF1
Link Failure: NOS Transmit State
LF2
Link Failure: NOS Receive State
OL1
Offline: OLS Transmit State
OL2
Offline: OLS Receive State
OL3
Offline: Wait for OLS State
8001
Retry loop init
8002
Start loop after gaining sync
8003
Restart loop after port reset
8004
LIP when a loop hangs
8005
Restart loop if LIP received when sending out ARB(F0)
8006
LIP when an OPN returns
8007
Restart loop when LIPs received in OLD_PORT AC state
8008
Restart loop if loop not empty but E_Port loopback
8009
LIP as requested by the LINIT ELS received
800a
LIP as requested by the LPC ELS received
800b
Restart loop for QuickLoop looplet setup
800c
Restart loop for QuickLoop looplet re-initialization
Start negotiation
Negotiate master
Wait for signal
Negotiation follow
Negotiation complete
Specify the maximum number of lines to display. Only the most recent
count entries are displayed.
Specify a nonzero value to display the saved port log from the last switch
fault. See
for a list of conditions that cause a fault. The count
upTime
is ignored when displaying the saved log.
Specify the area number of port to be displayed. If a port area number is
specified, all other ports on the switch are ignored.
Advertisement
Table of Contents
