HP StorageWorks 2/64 - Core Switch Command Reference Manual page 642

systemGroup configuration parameters
sysDescr
sysLocation
sysContact
authTraps
Operands
This command supports the following operands:
--show
--set
--default
--show, --set, and --default support the following:
snmpv1
snmpv3
accessControl
mibCapability
systemGroup
642 Fabric OS commands
System description. The default value is Fibre Channel Switch.
Location of the system (switch). The default value is End User Premise.
Contact information for this system (switch). The default value is set as Field
Support. See the definition of sysDescr, sysLocation, and sysContact in
system group of MIB-II.
When enabled, the authentication trap (authenticationFailure) is transmitted to
a configured trap recipient in the event that the agent received a protocol
message that is not properly authenticated. In the context of SNMPv1 and
SNMPv2c, this means that a request contains a community string that is not
known to the agent. The default value for this parameter is 0 (disabled).
Displays the SNMP agent configuration data of the specified category.
Sets the SNMP agent configuration data of the specified category. This
operand displays the current settings, and then prompts you to change the
values for each parameter.
Sets the SNMP agent configuration data for a specified item to the default
values. Generally, these default values might be available in the configuration
database. Factory default settings are set if the SNMP agent configuration
parameters are not available in the configuration database.
Selects SNMPv1-related configuration parameters. SNMPv1 parameters
include the community string, trap recipient IP address, and trap severity level
associated with each trap recipient IP address.
Selects SNMPv3-related configuration parameters. SNMPv3 parameters
include user name, authentication protocol and password, SNMPv3 trap
recipients IP address, associated user index, and trap severity level.
Selects access-control-related parameters. accessControl parameters include
access host subnet area and access permission (read-write).
Selects configuration parameters related to the SNMP agent's MIBs and trap
capability parameters. mibCapability parameters include MIBs and traps
supported by the SNMP agent.
Selects configuration parameters related to the system group. systemGroup
parameters include sysDescr, sysLocation, sysContact, and authentication
failure trap.