Diagloopid - HP StorageWorks 2/64 - Core Switch Command Reference Manual
Hp storageworks fabric os 5.x command reference guide (aa-rvhvb-te, september 2005)
Hide thumbs
Also See for StorageWorks 2/64 - Core Switch:
- Reference manual (278 pages) ,
- Installation manual (166 pages) ,
- Administrator's manual (152 pages)
Table of Contents
Advertisement
diagLoopId
Sets the diagnostics loop ID.
Synopsis
diagloopid [id | -show]
Availability
admin
Description
Use this command to select the loop ID to be used by FL mode diagnostics. The value entered will be
converted from a loop ID to the corresponding AL_PA and used as the port address for any diagnostics
that operate in FL_Port mode.
The mode becomes active as soon as this command is executed; it does not require a reboot to take effect.
The actual behavior of
NOTE:
Currently, no FL mode tests exist.
Operands
This command has the following optional operands:
id
-show
If no operand is specified, the current value is displayed.
Examples
To display the loop ID:
switch:admin> diagloopid -show
FL mode Loop ID is 125.
Notes
Currently, no FL_Port mode tests exist.
148 Fabric OS commands
depends on the test methods that use it.
diagLoopId
Specify the loop ID for FL_Port mode diagnostics.
Specify -show to display the current loop ID.
Advertisement
Table of Contents
