Agtcfgset - HP StorageWorks 2/64 - Core Switch Command Reference Manual

agtCfgSet

Modifies the SNMP agent configuration.
Synopsis
agtcfgset
Availability
admin
Description
Use this command to modify the configuration of the SNMP agent in the switch.
All values successfully configured by this command take effect immediately. These values are persistent
across power cycles and reboots. For dual-domain systems, this command operates on the SNMP agent
associated with the current switch.
This command updates the following values (See the HP StorageWorks Fabric OS 5.x MIB reference
guide for detailed sysDescr, sysLocation, and sysContact descriptions):
sysDescr
sysLocation
sysContact
authTrapsEnabled
There are six communities and respective trap recipients supported by the agent. The first three
communities are for read-write (rw) access and the last three are for read-only (ro) access. The default
value for the trap recipient of each community is 0.0.0.0. The default values for the community strings are
as follows:
Community 1: Secret Code
•
• Community 2: OrigEquipMfr
Community 3: private
•
• Community 4: public
• Community 5: common
• Community 6: FibreChannel
For an SNMP management station to receive a trap generated by the agent, the administrator must
configure a trap recipient to correspond to the IP address of the management station. In addition, the trap
recipient must be able to pass the access control list (ACL) check.
The system (switch) description. The default value is Fibre Channel
Switch in most platforms; however, the default system description
value is platform specific. Different values might appear as the
default for some specialized platforms.
The location of the system. The default value is End User Premise.
The contact information for the system. The default value is Field
Support.
When enabled, the authentication trap, authenticationFailure, is
transmitted to a configured trap recipient in the event the agent
received a protocol message that is not properly authenticated. In
the context of SNMPv1 and SNMPv2c, this means that a request
contains a community string that is not known to the agent. The
default value for this parameter is 0 (disabled).
Fabric OS 5.x command reference guide 29