Service Personnel Initial Settings Table 2.9.1 (6/7) - Oki OKIOFFICE44 Service Manual

Service Personnel Initial Settings Table 2.9.1 (6/7)

T.F.
Item
No.
27 Strobe for LED head
MSB
Setting
Rank
LSB
Marking
291–313
269–290
248–268
229–247
212–228
196–211
181–195
168–180
155–167
143–154
132–142
122–131
113–121
105–112
100–104
Installation Procedure
Setting of LED print head strobe signals (00000-
11111).
Selection of strove width in LED head.
"00000" is darkest and "11111" is lightest.
Note 1: When the rank marking of the new replaced
Note 2: Intensity ranking is determined by the first,
Also:
This setting should be verified upon initial install of
machine, or replacement of main control PCB or LED
Head.
Setting of Technical Function No. 27
0 0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0 1 1 1
0 0 0 0 1 1 1 1 0 0 0
0 0 1 1 0 0 1 1 0 0 1
0 1 0 1 0 1 0 1 0 1 0
*
*
2 - 24
Specifications
LED print head (new part) is same as that of
the old used LED print head (old part), you
do not always have to set the LED print
head strobe signal.
second and third digits from the right on the
LED print head serial number.
(i.e. in .... 212, 212 is the intensity ranking.)
0 0 0 0 0 1 1 1 1 1 1
1 1 1 1 1 0 0 0 0 0 0
0 0 1 1 1 0 0 0 0 1 1
1 0 0 1 1 0 0 1 1 0 0
1 0 1 0 1 0 1 0 1 0 1
*
*
*
*
*
*
*
*
*
*
*
Service Manual, P/N 59276801
Default
10100
1 1 1 1 1 1 1 1 1 1
0 0 1 1 1 1 1 1 1 1
1 1 0 0 0 0 1 1 1 1
1 1 0 0 1 1 0 0 1 1
0 1 0 1 0 1 0 1 0 1
*
*
OKIOFFICE 44