Oki OKIOFFICE44 Service Manual page 142

j) Motor-S:
Remove the Motor-S by removing the connector
of motor and the two screws 1.
k) Photo-Sensor (PC1, PC2):
After disconnecting the two connectors, remove
the photo-coupler sensors PC1 and PC2 on the
Plate Scanner B by pressing the latch using the
flat screwdriver or like.
(2) Reassembly procedure
Reverse the disassembly procedures.
4.1.3.6 Board-R44, OKIOFFICE 44 Power Supply
Disassembly
Plate Scanner B
4 - 14
Service Manual, P/N 59276801
Connector
Motor-S
Screw 1
(CP4.1 Fig. 19)
PC1
PC2
(CP4.1 Fig. 20)
OKIOFFICE 44
Rev. 2